A properly installed interior perimeter drain system intercepts groundwater at the slab edge and routes it to a sump basin before it ever reaches your floor.
Drain tile that isn't sloped correctly is one of the most common installation failures we see when repairing someone else's prior work — water simply pools instead of flowing to the basin. We verify slope with a level, not by eye.
We're licensed and insured for residential and light commercial interior drainage work across Westport, NC.
Interior drainage installs are scheduled locally, without routing through a national call center that adds weeks to the timeline.
Pricing is based on linear footage of drain tile needed, quoted in writing after an in-person measurement.
Every system is tested with a hose before we consider the install complete.
Every Westport, NC Interior Drainage System job starts with an inspection, not a generic package — here's what that typically includes.
A channel is cut along the slab edge, perforated pipe is laid with proper slope, and gravel backfill allows water to flow freely into the drain.
Every interior drain system needs a sump basin as its endpoint — we size the basin and pump to match the drain tile's expected inflow.
For finished basements where cutting the slab isn't practical, a baseboard channel system captures wall seepage without disturbing existing flooring.
The cove joint where wall meets floor is sealed and tied directly into the drain system so water is captured right at the entry point.
Existing drain tile that's clogged with silt or has failed slope can often be cleaned or repaired rather than fully replaced.
Tell us where water shows up and under what conditions — heavy rain, snowmelt, or constantly — so we can scope the likely system needed.
A technician checks where water is entering, measures the perimeter, and identifies the best sump basin location for discharge.
We explain why we're recommending full perimeter versus targeted sections based on what the inspection found.
Most residential interior drainage installs finish in one to three days depending on perimeter length.
"Water was coming in along one wall every heavy rain. They installed targeted drain tile just on that section instead of charging us for the whole perimeter."
— Westport Homeowner
"Finished basement meant we couldn't cut the slab easily. Baseboard channel system worked great as an alternative."
— Westport Customer
"Explained the slope requirements in a way that actually made sense, not just technical jargon."
— Westport Homeowner
"Sump basin placement was smarter than what a previous contractor had proposed — shorter discharge run, less noise."
— Westport Customer
Not always — if water is only entering along one wall, a targeted section can be enough, which we determine from inspection findings.
We'll recommend whichever fits your basement's finish level and budget.
{Sometimes — if the pipe itself is intact but clogged with silt, cleaning can restore function without a full re-installation.|We camera-inspect where accessible to make that determination before recommending replacement.}
An undersized basin cycles the pump too often, so we don't cut corners on sizing.
Cutting the slab does involve some disruption, but we work in sections and clean up debris as we go.
We give you a realistic timeline in the written quote based on your specific basement layout.
We install and repair interior drainage systems throughout Westport and the surrounding Westport, NC service area, including the zip codes listed below.
Zip codes we serve in Westport, NC: 28037
Call now for a free inspection and a flat-rate quote before anything gets worse.
Call +1-866-476-1348© SGP Waterproofing. All rights reserved.
